SATO MB200/201i - Manual (Page 40)

Operation and Configuration
3-10
Adjusting printing for Non-separate labels
When printing on a continuous label roll (non-
separate), if you tear off a label at the wrong
place, proceed as follows.
1. Interrupt printing on the
computer, or by pressing
the PRINT key in the
ONLINE state to take the
printer OFFLINE.
(STATUS LED goes off).
2. Press the FEED button to
feed a label. When the
feeding stops, tear off the
label correctly by pulling
the label in the direction
of the arrow shown in the
diagram. The label is now
aligned properly for
printing to resume.
3. Press the PRINT button to return to the online state
(STATUS LED lights green). You can now resume
the print job.
MB20xi A6.book Page 10 Friday, May 27, 2005 5:12 PM