SATO MB200/201i - Manual (Page 29)

Setup
2-15
Installing the label roll (cont’d)
3. Insert the label roll into
the printer. Make sure the
first label emerges from
the bottom (not top) of the
roll.
4. Lift up the label guide
adjust dial cover and turn
the dial till the label
guides press loosely
against label roll. Turn the
label roll lightly by hand
and confirm that it rotates
smoothly. Otherwise the
paper may not be fed
correctly during
operation. Close the dial
cover.
* When replacing a label
roll of the same width as
that used previously,
adjustment of the label
guide is not necessary.
Ensure that the first label
emerges from the bottom
(not top) of the roll.
MB20xi A6.book Page 15 Friday, May 27, 2005 5:12 PM