SATO MB200/201i - Manual (Page 32)

Operation and Configuration
3-2
Performing a Test Print
Users can perform test prints to evaluate the print
quality and also diagnose problems.
1. Set the printer DIP switch for
Test Print mode as shown
on pages 4-2/4-3.
2. Press the POWER button
while pressing and holding
down the FEED button. The
printer enters the test mode.
Press the FEED button
again to do a test print.
3. Verify the following using the
output of the test printing.
• All printed characters are
solid black, without any chipped areas.
• Overall print quality is readable and sharp.
A low battery condition may affect the print quality.
Make sure the printer is running on AC or on a full
battery during a test print.
Notes:
If any fault is detected, contact your SATO dealer or
service center. Before asking for a repair, please read
the Troubleshooting section of this manual.
MB20xi A6.book Page 2 Friday, May 27, 2005 5:12 PM