SATO MB200/201i - Manual (Page 36)

Operation and Configuration
3-6
Printing via the Bluetooth Interface
To print using the Bluetooth-enabled version of
MB200/201i, you need to have a bluetooth-enabled
computing device. Two more steps are required.
1) Check the DIP Switches:
The printer’s DIP switches are factory set for bluetooth
operation. Check that Dip switch 1 is OFF and Dip switch 2 is
ON. This is the main setting for Bluetooth operation. In case you
need to reset other switches, refer to the full DIP-Switch table in
the next chapter, Interface Specifications.
2) Synchronize Bluetooth settings
After setting the DIP-switches, the next step is to
ensure that both bluetooth devices are configured to
operate with the same PIN code and Authentication
mode settings. Refer to the instruction manual of the
computing device for details on how to set these
parameters.
For the MB200/201i, these parameters can be set by
a SATO-certified System Integrator/dealer, or by
using Bluetooth communication software available
from your SATO dealer or service center.
Note
When printing with the Bluetooth interface, the usable
range between the printer and the host may vary
depending on the usage environment and the
capabilities of the connected devices.
MB20xi A6.book Page 6 Friday, May 27, 2005 5:12 PM