SATO MB200/201i - Manual (Page 30)

Setup
2-16
Installing the label roll (cont’d)
3. Close the cover after
confirming that the leading
edge of the label is outside
the printer by at least
10 mm.
* When using non-
separate labels, press
the FEED button to feed
a piece of label and pull
the label upward to cut it
along the perforation. If
the label becomes
jammed, retry the label
setting procedure.
4. Push the dispenser unit
forward so that it covers
the red platen roller.
This completes the label installation for
Dispense mode operation. To resume operation
in Continuous mode, lift the top edge of the
dispenser unit (where two arrow marks are
imprinted) to it downwards. In Continuous
mode, the red platen roller will be visible.
MB20xi A6.book Page 16 Friday, May 27, 2005 5:12 PM