SATO MB200/201i - Manual (Page 42)

Operation and Configuration
3-12
Configuring Dispense mode
Dispense Mode can be set to Auto Print or Manual
Print, as described below.
To switch between Auto or Manual Print for the
Dispense Mode, set the DIP switches and then hold
down the PRINT or FEED button when turning the
printer ON. The new settings take effect when the
printer is next turned ON.
When setting the dispense mode, the STATUS LED
blinks green, and turns into a steady green signal
upon completion of setting. Turn off the printer ONLY
when the STATUS LED is a steady green light.
Type Operation
Auto Print Prints one label after receiving data and waits for peeling.
After peeling a label, automatically prints next label.
Manual
Print (this
is the
default set-
ting) Prints one label after receiving data and enters offline
state. Pressing the PRINT key allows next label to be
printed. After printing the specified number of labels, print-
ing terminates. No printing occurs even when the PRINT
key is pressed.
Setting Auto Print dispense mode:
DSW1-4=OFF,OFF,OFF,ON + Cover open + Print
button + power ON
Setting Manual Print dispense mode:
DSW1-4=OFF,OFF,OFF,ON + Cover open + FEED
button + power ON
MB20xi A6.book Page 12 Friday, May 27, 2005 5:12 PM