Sun Microsystems FIRE V40Z - Manual (Page 71)

Chapter 3 SNMP Server Management 49
Configuring SNMP Trap Destinations
Although SNMP traps are generated for events that occur on the SP, you must
configure where these traps are to be sent. There is no default destination for traps.
You can use the server-management subcommands (see
TABLE 3-2 ) on the SP to
configure SNMP destinations.
For more information on these subcommands, refer to Appendix B .
Configuring SNMP Destinations
Administration- and manager-level users can define SNMP destinations to which
SNMP events (alerts) will be sent using this option. All users can view the current
destinations (using read-only access).
The number of destinations you can create is limited due to memory constraints.
TABLE 3-2 Subcommands for Configuring SNMP Destinations
Subcommand Description
sp get snmp-destinations Displays all the available SNMP destination
IP addresses and host names to which the SP will send.
sp add snmp-destination Adds a new SNMP destination one IP address or host
name at a time.
sp delete snmp-
destination
Removes an existing SNMP destination one IP address
or host name at a time.