Sony STR-DG1000 - Manual (Page 44)

44 GB
1
Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the display.
2
Press V/v repeatedly to select
the item, then press .
3
Press V/v repeatedly to select a
preset number to be used, then
press .
4
Press .
The measurement results are saved.
Tip
The size of a speaker (LARGE/SMALL) is
determined by the low characteristics. The
measurement results may vary, depending on the
position of the optimizer microphone and speakers,
and the shape of the room. It is recommended that
you follow the measurement results. However, you
can change those settings in the Speaker Settings
menu (page 66). Save the measurement results first,
then try to change the settings if you want.
When error codes appear
Try the remedies and re-perform the auto
calibration.
Confirming/saving the
measurement results
Measurement
result Display Explanation
When the
measurement
process
completes
properly COMPLETE Proceed to step
2.
When the
measurement
process fails ERROR
CODE XX See “When
error codes
appear” (page
44).
Item Explanation
RETRY Re-performs the auto
calibration.
SAVE EXIT Saves the measurement
results and exits the setting
process.
WRN CHECK Displays a warning
concerning the
measurement results. See
“When you select “WRN
CHECK”” (page 45).
PHASE INFO Displays the phase of each
speaker (in phase/out of
phase). See “When you
select “PHASE INFO””
(page 45).
DIST.INFO Displays the measurement
result for speaker distance.
LEVEL INFO Displays the measurement
result for speaker level.
EXIT Exits the setting process
without saving the
measurement results.
Error code Cause and remedies
CODE 31 SPEAKERS (OFF/A/B/A+B) is
set to OFF. Set it to others and re-
perform the auto calibration.
CODE 32 None of the speakers were
detected. Make sure that the
optimizer microphone is
connected properly and re-
perform the auto calibration.
If the optimizer microphone is
connected properly but the error
code appears, the optimizer
microphone cable may be
damaged or improperly
connected.
CODE 33 (F) None of the front speakers are
connected or only one front
speaker is connected.
The optimizer microphone is not
connected.
Item Explanation