Suburban Mfg REGAL INTENSIVE CARE UNIT 12019-01-NGFREP - Manual (Page 67)

Form No. 702718 Rev. A March, 2005 55
Owner’s Manual - Regal Intensive Care Unit
Using the Alarm
System
The alarm system alerts you, with audible and visual signals, when-
ever there is a problem with the oxygen supply or concentration.
Turning the alarm system on
1. Make sure the main on/off switch is On. The amber light
in the switch should be On (refer to Page 48).
2. Make sure the oxygen on/off switch is On. The amber
light in the switch should be On (refer to Page 51).
Note: The alarm system only operates when the oxygen
system is On.
3. Push the alarm on/off switch to On. The amber light in the
switch comes on (Figure 58). The alarm system is now in
the operating mode.
Turning the alarm system off
Push the alarm on/off switch to Off. The light in the switch goes out.
Recognizing an alarm
When an alarm occurs, the audible alarm sounds and the red alarm
system light comes on.
Responding to an alarm
1. Push the five system on/off switches to
Off , starting at the oxygen on/off switch
and proceeding down (heat, cooling, alarm,
left floor heat, right floor heat). The lights in
all the switches, and all system lights go out.
2. Push the main on/off switch to Off. The
light in the switch goes out (refer to
Page 48).
3. Locate and fix the problem.
4. Re-start the unit and continue normal
operating procedures.
Figure 58. Alarm Controls
System
Light
On/Off
Switch