Suburban Mfg REGAL INTENSIVE CARE UNIT 12019-01-NGFREP - Manual (Page 93)

Form No. 702718 Rev. A March, 2005 81
Owner’s Manual - Regal Intensive Care Unit
Divider Panel
Wire Grill - P/N 206001
Clear Acrylic - P/N 749575
Two divider panels are provided with the Intensive Care Unit.
Although different in appearance, they are removed and installed in
the same way.
Removal
1. Open both animal compartment doors.
2. Remove the PVC floor (if installed) from the right
compartment.
Note: Notice the guide channels for the divider panels in the rear
wall and ceiling of the animal compartment (Figure 89).
3. Pull out the divider panel slightly so that it
clears the rear channel.
4. Tilt the lower edge of the divider panel to
the right until the top edge clears the top
guide channel.
5. Remove the divider panel.
Installation
1. Orient the divider panel so that the
notched corner is on top and toward the
front (Figure 90).
2. Tilt the top of the divider panel to the left,
and place it intothe top guide channel.
3. Swing the lower edge of the panel to the
left so that the panel is vertical.
4. Push the panel to the rear so that the back
edge seats in the rear guide channel.
5. Replace the PVC floor, if desired.
6. Close the animal compartment doors.
Figure 89. Top and Rear Divider Panel
Guide Channels
Top Guide
Channel
Rear Guide
Channel
Figure 90. Notched Corner on the Wire
Grill Divider Panel.
Notched
Corner
The clear, acrylic divider has a similar notch.