Sony RM-NX7000 - Manual (Page 20)

20
Continued
Location and Function of Controls
Battery charging stand
w; DC IN jack
Used to connect the supplied AC power adaptor.
About the DC IN jack
The supplied AC power adaptor can be connected to the DC IN jack of the Remote
Commander or the DC IN jack of the Battery charging stand. You can charge and operate
the Remote Commander with either connected. It is recommended to connect the AC
power adaptor directly to the DC IN jack of the Remote Commander when importing/
exporting data with the supplied USB cable to prevent disconnecting the AC power
adaptor by mistake.
w;
qk Infrared emitter
ql RESET button
Used to restart the Remote Commander. Press this button with the supplied
Stylus when the Remote Commander does not work at all even if you press
the touch panel display. Make sure not to press this button when the touch
panel display works normally. The Remote Commander will be restarted
even while setting. When you restart the Remote Commander, be sure to
connect the supplied AC power adaptor. If the AC power adaptor is not
connected, the Remote Commander will not be restarted even if you press
the RESET button. After the Remote Commander is restarted, set the system
clock again.