Sony RM-NX7000 - Manual (Page 243)

243
Additional Information
Trouble with the macro setting
Symptom
The macro function does not
operate correctly.
When trying to perform the Viewer
function to check the macro
procedure programmed for a
Component key, a function key or a
function button, an error message
appears and a check cannot be
performed even if you select a key
or button.
Remedy
• Make sure to program a series of actions in the
correct order (page 123).
• Try changing the orientation of the Remote
Commander. If that does not help, try placing
the component as close to the Remote
Commander as possible.
• Check the status of the component and make
sure you set the component properly to receive
signals.
• The settings for a key or button that has been
programmed with a macro (series of actions)
may be changed. In this case, the new signals
are transmitted when the macro (series of
actions) is executed.
• The interval may be too short. See “About the
interval between operation steps ([DELAY]
key)” (page 122) and set a longer interval, or
adjust the series of actions by changing the
order of buttons and keys. (See “About the
order of operation steps” (page 122).)
• You may have programmed the macro
procedure only with the Jump or Delay
function. If the macro procedure is
programmed only with the Jump or Delay
function, you cannot check the macro
procedure by the Viewer function.
Continued
Trouble with the application mode
Symptom
You cannot return to the Home
display from the application mode.
Images transferred from “NAVITUS
Design” do not appear even if you
select [WALL ALBUM].
Remedy
• Keep the COMMANDER OFF button pressed
for 2 seconds or longer.
• Only image files that are set to the project can
be transferred from “NAVITUS Design.” Set the
images to be shown as the wallpaper for the
Home or Component display with “NAVITUS
Design.”