Sony RM-NX7000 - Manual (Page 244)

244
Troubleshooting
Continued
Trouble with a “Memory Stick”
Symptom
A “Memory Stick” cannot be
inserted.
Even if you insert a “Memory
Stick”, a beep sounds twice and the
“Memory Stick” cannot be detected.
The detection message is not
shown, or an error occurs when
inserting a “Memory Stick.”
Remedy
• The inserting direction is incorrect. Insert the
“Memory Stick” in the correct direction.
• You may have locked the operation mode.
While pressing the [EXIT] button, press and
hold the [VOL–] button, and while pressing
these two buttons, press the [CH–] button
(page 38). The operation lock will be released.
• The settings are locked and cannot be edited.
Release the lock (page 223).
• The Remote Commander may be in the
application mode, or detecting USB. While the
Remote Commander is in the application
mode, or detecting USB, a “Memory Stick”
cannot be detected. Check the status of the
Remote Commander.
• The “Memory Stick” is not detected properly.
Remove the “Memory Stick”, then reinsert it.
• If the terminal of a “Memory Stick” is dirty,
reading/writing of data may not be possible.
Clean the terminal of the “Memory Stick” with
a cotton swab.
• You may not be able to use a “Memory Stick”
which was formatted using a device other than
the Remote Commander. Format the “Memory
Stick” using the Remote Commander.
• When the batteries in the Remote Commander
are exhausted, data you have saved in the
“Memory Stick” may not be shown. In this
case, charge the Remote Commander.