Sony RM-NX7000 User Manual

Page 51

Advertising
background image

51

Basic Oper

ations

■

When the component to be registered does not function properly

The selected preset code may be incorrect. Select again the preset code by
pressing the [v] or [V] key, aim the Remote Commander at the component
to be registered, and then press the [TEST] key again. Repeat this operation
until the component to be registered functions properly.

■

When the component to be registered functions properly

The correct remote control signal was transmitted. Go to step 4.

4

Press the [OK] key.

The preset code is programmed for the Remote Commander and the
display returns to the component selection display (step 3 on page 43).

z

Tip

If you press the [CANCEL] key, the preset code will not be programmed and the
display will return to step 1 on page 50.

5

To finish all settings, press the COMMANDER OFF
button for 2 seconds or longer.

The display returns to the Home display. Or press the [EXIT] key
repeatedly until the Home display is shown.

Advertising