Sony RM-NX7000 - Manual (Page 28)

28
Continued
Setting up the Remote Commander using “NAVITUS Design”
5
Select “Install the software automatically [Recommended]”,
then click [Next].
Installing of the USB driver starts.
The “Completing the Found New Hardware Wizard” display appears when
the installation is complete.
6
Click [Finish].
Installing of the USB driver finishes.
For Windows 2000 users
1 Close all software running on Windows.
2
Insert the supplied CD-ROM in the CD-ROM drive of the computer.
After a moment, “InstallShield Wizard” of “NAVITUS Design” appears.
3
Click [Cancel] to close “InstallShield Wizard” of “NAVITUS Design.”
4
Connect a computer and the Remote Commander using the
supplied USB cable.
The “Found New Hardware” message appears. After a moment, “Found
New Hardware Wizard” appears.
5
Click [Next].
The “Install Hardware Device Drivers” display appears.
6
Select “Search for a suitable driver for my device
[recommended]”, then click [Next].
The “Locate Driver Files” display appears.
7
Mark only the check box of “CD-ROM drives”, then click [Next].
The “Driver Files Search Results” display appears, and the found driver is
displayed.
8
Click [Next].
Installing of the USB driver starts. The “Completing the Found New
Hardware Wizard” display appears when the installation is complete.