KORG Speaker System - Manual (Page 134)

130
Click the [OK] button, and then click [OK] again.
6 Make settings as described in “Setting up the Korg
MIDI Driver” (below), and click the [OK] button.
7 Be sure to restart your computer so that the new
driver becomes effective.
Korg MIDI Driver settings
1 In “Control panel,” double-click the “Multimedia”
icon, and the “Multimedia Properties” dialog box
will appear.
Click the “Advanced” tab located at the upper right.
Click the [+] located at the left of “MIDI Devices and
Instrnments” (the display will change to [–]), and
click “KORG PC I/F MIDI Port.”
Then click the [Properties] button.
2 “KORG PC I/F MIDI Port Properties” will appear.
Click the [Settings] button.
3 Make settings as described in “Setting up the Korg
MIDI Driver” (below), and click the [OK] button. If
you change the settings, you must restart Windows.
Setting up the Korg MIDI Driver (Win-
dows)
1 For Serial Port, select the serial port (“COM1” to
“COM4”) to which the TRITON is connected. If you
wish to use the serial port for a different purpose
after installing the Korg MIDI Driver, you can either
select “None” to disable the driver, or “Delete” the
driver and restart Windows.
2 If “Independent Synth/MIDI Out” is not checked,
data that is output to Default MIDI will be sent both
to the tone generator and to MIDI OUT. If “Indepen-
dent Synth/MIDI Out” is checked, the operation
will depend on the model of tone generator that you
are using.
Since the TRITON does not support this function,
do not check Independent Synth/MIDI Out.
3 Synth Out Messages allows you to select the mes-
sages that will be transmitted to the TRITON. MIDI
Out Messages allows you to select the messages that
will be output from the MIDI OUT of the tone gen-
erator.