KORG Speaker System - Manual (Page 30)

26
4 To release the locked condition, press the [SW1]
key once again.
Ribbon controller
When the [SW1] or [SW2] key function is set to Ribbon
Lock
, the sound produced by moving the ribbon con-
troller can be held even after the ribbon controller is
released.
When the [SW1] key is set to Ribbon Lock and is oper-
ating as a Toggle switch, the lock function can be used
as described in the following example.
1 Press [SW1] (the [SW1] key LED will light).
2 Move your finger to left or right on the ribbon con-
troller. The sound will change.
3 Even when you remove your finger from the rib-
bon controller, the sound at that point will be held.
This is the “locked” condition.
4 To release the locked condition, press the [SW1]
key once again.
When the [SW1] or [SW2] key function is assigned
to JS X & Ribbon Lock, JS+Y & Ribbon Lock, or
JS–Y Ribbon Lock
, both locking functions will
apply simultaneously.
After touch
When the [SW1] or [SW2] key function is set to After
Touch Lock
, the sound produced by applying pressure
to the keyboard can be held even after the keyboard is
released.
When the [SW1] key is set to After Touch Lock and is
operating as a Toggle switch, the lock function can be
used as described in the following example.
1 After playing a note, apply pressure to the key-
board (after touch). The sound will change.
2 While maintaining the pressure on the keyboard,
press [SW1] (the [SW1] key LED will light).
3 Even when you apply further pressure to the key-
board, the sound at the moment you pressed [SW1]
key will be held.
This is the “locked” condition.
4 To release the locked condition, press the [SW1]
key once again.
These knobs can be used to control the filter cutoff fre-
quency and resonance, the amp and filter EG, volume,
portamento time, pan, pitch LFO, or the send levels to
the master effects, etc.
1 Press the [REALTIME CONTROLS] key to switch
the function of the realtime controllers to A mode
or B mode.
Each time you press the key, A mode or B mode will
be selected alternately, and the corresponding LED
will light.
2 Rotate the desired knob to control the sound, etc.
A mode controls
In A mode, knobs [1]–[4] will control/edit the follow-
ing functions.
Placing the knobs in the center (12 o’clock) position
will produce the values specified by the program
parameters.
Knob [1]: LPF CUTOFF
Adjust the cutoff frequency of the low pass filter.
When you adjust the cutoff frequency of the filter, the
brightness of the sound will change. The effect will
depend on the settings of the program parameters, but
normally, rotating the knob toward the left will darken
the sound, and rotating it toward the right will
brighten it.
Knob [2]: RESONANCE/HPF
Adjust the resonance level of a low pass filter or the
cutoff frequency of a high pass filter.
The content that is controlled will depend on the filter
type specified by the program.
Realtime control knobs
[1], [2], [3], [4]
The selected mode
will light.
Frequency
High Low
Cutoff
frequency
Level
LPF