KORG Speaker System - Manual (Page 69)

65
Basic functions
4 Press the [REC/WRITE] key, and then press the
[START/STOP] key.
If “Metronome Setup” has the default settings (refer
to “Preparations for recording” step 5), the metro-
nome will sound for a two-measure pre-count, and
then recording will begin. Play the keyboard and
move controllers such as the joystick to record your
performance.
5 When you finish playing, press the [START/STOP]
key.
Recording will end, and the location will return to
the point at which you begin recording.
At this time if you press the [PAUSE] key instead of
the [START/STOP] key, recording will pause. When
you press the [PAUSE] once again, recording will
resume. When you are finished, press the [START/
STOP] key to stop recording.
Overdub
1 Make the necessary settings in “Preparations for
recording.”
2 In the Preferences tab “Recording Setup,” select
Over Dub.
3 For the rest of the procedure, refer to steps 3–5 of
“Overwrite” ( ☞ p.64).
Manual punch-in
1 Make the necessary settings in “Preparations for
recording.”
2 In the Preferences tab “Recording Setup,” select
Manual Punch In.
3 In “Location,” specify a location several measures
earlier than the point at which you wish to begin
recording.
4 Press the [START/STOP] key.
Playback will begin.
5 At the point at which you wish to begin recording,
press the [REC/WRITE] key.
Recording will begin. Play the keyboard and oper-
ate controllers such as the joystick to record your
performance.
6 When you finish recording, press the [REC/
WRITE] key.
Recording will end (playback will continue).
Instead of pressing the [REC/WRITE] switch in
steps 5 and 6, you can use a foot switch connected
to the [ASSIGNABLE SWITCH] jack. Set the Global
P2: Controller “Foot Switch Assign” to Song Punch
In/Out (
☞ p.125).
7 Press the [START/STOP] key.
Playback will stop, and you will return to the loca-
tion that you specified in step 3.
Auto punch-in
1 Make the necessary settings in “Preparations for
recording.”
2 In the Preferences tab “Recording Setup,” select
Auto Punch In.
3 In “M__–M__” specify the area that you wish to
record.
For example if you specify M005–M008, recording
will occur only from measure 5 to measure 8.
4 In “Location,” specify a location several measures
earlier than the point at which you wish to begin
recording.
5 Press the [REC/WRITE] key, and then press the
[START/STOP] key.
Playback will begin.
When you reach the starting location you specified
in step 4, recording will begin. Play the keyboard
and operate controllers such as the joystick to record
your performance. When you reach the ending loca-
tion you specified in step 4, recording will end.
(Playback will continue.)
6 Press the [START/STOP] key.
Playback will stop, and you will return to the loca-
tion you specified in step 4.
Loop All Tracks
1 Make the necessary settings in “Preparations for
recording.”
2 In the Preferences tab “Recording Setup,” select
Loop All Tracks.
However since multitrack recording is not possible,
the “MultiRec” check box must be unchecked.
3 In “M__–M__” specify the area that you wish to
record.
For example if you specify M004–M008, recording
will occur repeatedly (as a loop) from measure 4 to
measure 8.
4 In “Location,” specify a location several measures
earlier than the point at which you wish to begin
recording.
Sequencer mode