KORG Speaker System - Manual (Page 90)

86
When the “Status” of a track is set to EXT or BTH, the
data played back by that track and the data produced
by operating the keyboard or controllers of the TRI-
TON will play and control an external tone generator.
(The MIDI channel of the external tone generator must
match the “MIDI channel” of the TRITON track that is
set to EXT or BTH.) With a setting of BTH, the external
tone generator and the TRITON’s own tone generator
will be played and controlled simultaneously. (
☞ p.104
in the Parameter Guide “Status”)
GM/GS/XG playback
When you wish to playback SMF data that is compati-
ble with the GM/GS/XG standards, set “Bank Map”
(Global P0: System Pref. tab) to GM(2) (
☞ p.123).
( ☞ p.115 in the Parameter Guide).
Synchronization with external devices
In Song Play mode, the TRITON will be the master (the
controlling device) regardless of the MIDI Clock set-
ting (Global P1: MIDI “MIDI Clock”) (
☞ p.122).
Mute/Solo function
In P0: Play/Mix, the Program T01–08 and T09–16 tabs
provide PLAY/MUTE buttons and SOLO ON/OFF
buttons
that allows you play and mute tracks 1–16 in
the same way as in Sequencer mode.
You can use these when you wish to mute the melody
track and play the part yourself on the keyboard
(“minus-one play”), or when you wish to audition a
track (
☞ p.62).
You can use the “Solo Selected Track” page menu com-
mand to audition only the currently selected track.
This provides a convenient way to hear the parameter
settings and effect settings of a track (
☞ p.47, 102 in the
Parameter Guide).
Insert effects and master effects
Refer to “About effects” ( ☞ p.108) ( ☞ p.109 in the Param-
eter Guide).
Direct playback from external media such as
a floppy disk
When you wish to playback SMF data that is com-
patible with the GM/GS/XG standards, set “Bank
Map” (Global P0: System Pref. tab) to GM(2).
1 Press the [S.PLAY] key to enter Song Play mode.
2 Insert a floppy disk containing SMF data into the
TRITON’s disk drive.
When the separately sold EXB-SCSI option is
installed. If you wish to load data from external
SCSI media such as a hard disk, refer to the EXB-
SCSI owner’s manual, and make sure that the exter-
nal SCSI drive etc. is connected. Also make sure that
the media contains SMF data.
3 Press either the [LOCATE], [START/STOP], or
[PAUSE] key.
Data will be loaded from the media.
If you press the [START/STOP] key, the data will be
loaded and playback will begin (the same as in step
6).
4 “File Select” will show the SMF filenames.
If there is no SMF data in the floppy disk, or if there
is no SMF data in the currently selected directory, no
filename will be displayed (as shown below).
If no jukebox list has been created, no filenames will
be displayed if the “Jukebox” check box is checked.
Uncheck the “Jukebox” check box.
Playing SMF data
File Select