KORG Speaker System - Manual (Page 83)

79
Basic functions
4 Use the AUDIO INPUT [LEVEL] knob to adjust a
suitable input level. (Refer to step 6 of “Connec-
tions and settings for a monaural source”)
The AUDIO INPUT [LEVEL] knob adjusts both
AUDIO INPUT 1 and 2.
Using an insert effect
The TRITON’s insert effects can be applied to the
sound that is being input from the AUDIO INPUT 1
and 2 jacks, allowing you to record a sample with
effects applied. As an example, we will explain the pro-
cedure for applying an insert effect to a stereo source
and sampling the result.
1 Make the settings of step 1 and 2 in “Connec-
tions and settings for a stereo source.”
2 Set the “Audio Input (SAMPLING)” parameters.
• Set “BUS (IFX) Select” to IFX1 for both Input 1
and 2.
• Set “Level” and “Pan” to the same settings as in
step 3 of “Connections and settings for a stereo
source.” With these settings, the stereo source
will be sent to insert effect 1 (IFX 1).
3 Use the AUDIO INPUT [LEVEL] knob to adjust a
suitable input level. (Refer to step 6 of “Connec-
tions and settings for a monaural source.”)
4 In P8: Insert Effect, select the Insert Fx tab.
Up to five insert effects can be connected in series.
Make settings for “Chain,” “Insert Effect,” and the
“Pan” of the sound after it has passed through the
insert effect. For details on the settings, refer to
p.109, 107, and to p.26, 99 in the Parameter Guide.
Examples of settings using the insert effects are
given in “Sample Mode” (p.82) in the Parameter
Guide.
Manual sampling
There are two methods of sampling: manual and auto.
In manual mode, sampling is started by pressing the
[START/STOP] key from the recording standby condi-
tion (entered by pressing the [REC/WRITE] key once).
For the sampling procedure in auto mode, refer to
“Auto sampling” (
☞ p.80).
1 In P0: Recording, select the Input/Setup tab.
2 Use the “Recording Setup” radio buttons to select
Manual.
This will select manual recording mode.
3 In P0: Recording, select the Recording tab.
4 Select “MS” the multisample (MS). For this exam-
ple, select 000: NewMS______000.
Immediately after the power is turned on, 000:
NewMS______000
will be created automatically.
Use the numeric keys [0]–[9] to input the multisam-
ple number that you wish to record, and press the
[ENTER] key. Alternatively, you can press the
popup button and select a multisample from the
popup menu. If you select a new number, the Create
New Multisample dialog box will appear. Press the
OK button
.
To specify the name, use the “Rename MS” page
menu command.
Chain
Recording Setup
MS
Recording Level [dB] meter
Recording Level [dB] slider
Sample Select
Sample Mode
Sampling mode