KORG Speaker System - Manual (Page 78)

74
For example if you are using tracks 1 and 2 for
RPPR playback and using track 3 for keyboard per-
formance, you would set REC only for tracks 1, 2,
and 3 as shown below.
5 Check the “RPPR” check box.
The RPPR function will be on.
6 In “Location,” specify the point at which recording
will begin.
It will not be possible to change the location if you
are recording the song for the first time, so proceed
to step 7.
7 Press the [REC/WRITE] key, and then press the
[START/STOP] key.
Recording will begin.
When you press a key to which a pattern is
assigned, that pattern will begin playing. Keys to
which no pattern has been assigned will sound as
usual for the track specified by “Track Select,” and
will be recorded.
If you want a pattern to begin playing at the
moment that recording begins, press the key dur-
ing the pre-count. (Make sure that the RPPR
“Sync” is set to SEQ.)
8 Press the [START/STOP] key.
Recording will end, and the location will return to
the point at which you began recording.
9 To cancel multitrack recording, uncheck the
“Multi REC” check box in step 3.
Single track recording
You can also use single track recording to record an
RPPR performance.
1 Make track settings in the same way as for multi-
track recording.
2 In P0: Play/REC, check the RPPR check box.
The RPPR function will be turned on.
3 In the same way as for single track recording of a
normal song, use “Track Select” to select the track
that you wish to record.
4 In “Location,” specify the point at which recording
will begin.
It will not be possible to change the location if you
are recording the song for the first time, so proceed
to step 5.
5 Press the [REC/WRITE] key, and then press the
[START/STOP] key.
Recording will begin.
In the case of single track recording, only the track
specified by “Track Select” will actually be
recorded even if the RPPR performance consists of
multiple tracks. Of the patterns that are assigned
by the RPPR settings, only the performance of the
patterns whose track matches will be recorded.
6 Press the [START/STOP] key.
Recording will end, and the location will return to
the point at which recording began.