KORG M3 - Manual (Page 100)

Creating songs (Sequencer mode)
92
• In the P8–1: IFX– Routing1 T01–08 page, route the
MIDI Track 01 Bus Select (IFX/Indiv. Out Assign)
to IFX1. Then in the P8–1: IFX– Insert FX Setup
page, select the desired effect for IFX1.
• Select MIDI Track 01 in Track Select. Then press
the SEQUENCER REC/WRITE switch and then the
START/STOP switch, and record a phrase of about
sixteen measures.
2. Select Track 09 in “Track Select,” and record
parameter changes as desired.
Note: For this example, select an empty track. If you
want to record onto a MIDI track that already contains
data, set the P0–1: Play/REC– Preference page
Recording Setup
to “Overdub,” as described on
page 86.
• Select Track 09 in Track Select. Then press the
SEQUENCER REC/WRITE switch and then the
START/STOP switch, and begin recording.
• At the appropriate time while recording, adjust the
parameter(s) that you want to realtime-record.
Select another effect for IFX1 in the P8–1: IFX– Insert
FX Setup page, and edit the effect parameter values, or
use the P0–2: Play/REC– Control Surface page Tone
Adjust controls to edit the sound in realtime.
Note: For details on the effects parameters that you can
record in real-time, please see “System Exclusive
events supported in Sequencer mode” on page 295 of
the Parameter Guide.
3. Stop recording.
Note: Exclusive messages are always recorded on the
current track selected by Track Select. In this example,
they are recorded on MIDI track 9.
Note: In the MIDI event edit page you can view the
recorded exclusive events and their location. Exclusive
events are displayed as “EXCL”.
To view these events, go to the P6: Track Edit– Track
Edit page, and select the menu command MIDI Event
Edit
. Then in the Set Event Filters dialog box, check
Exclusive and press the OK button.
Exclusive events cannot be changed to a different
type of event. Nor can other events be changed
into exclusive events.
4. If you go to the page (e.g., P8–1: IFX) that shows
the parameters you adjusted in realtime, you can
watch the recorded changes be reproduced while
the song plays back.
Exclusive messages that can be recorded in
real-time
The following exclusive messages can be recorded in
real-time:
• Exclusive messages received from an external MIDI
device
• Parameter changes in Sequencer mode (see “System
Exclusive events supported in Sequencer mode” on
page 295 of the Parameter Guide)
• Master Volume universal exclusive messages
assigned to the foot pedal or a slider
Using the control surface to record
changes in the pan, EQ, volume, and
tone adjust settings of a MIDI track
While performing realtime recording, you can use the
control surface to modify the pan, EQ, volume, and
tone adjust settings to record these changes so that
they will be reflected during the playback.
Use multi-track recording if you want to modify the
settings of multiple tracks simultaneously.
Note: Control you perform using the control surface is
transmitted as control change messages and system
exclusive messages. In order for this data to be
recorded, the Global P1: MIDI– MIDI Routing Enable
Control Change
and Enable Exclusive settings must
be checked. Go to Global mode and verify that these
items are checked.
Note: Use Param. MIDI Out to specify whether control
change messages or system exclusive messages will be
transmitted when you edit the Pan (CC#10), Volume
(CC#7), or Send 1/2 level (CC#93 and CC#91)
parameters.
In this case, the Global P1: MIDI– MIDI Routing
settings Enable Control Change and Enable Exclusive
must be checked respectively.