KORG M3 - Manual (Page 90)

Creating songs (Sequencer mode)
82
Control using the sliders and
switches
You can use the control surface to perform a variety of
control. You can perform this control in realtime
during playback or recording.
For example, you can adjust the volume of each track,
or change the cutoff or resonance. You can also turn
effects on/off or adjust their depth, or modify the
phrases generated by KARMA.
Here we will explain how to control the volume, mute,
and solo settings of each track. For other types of
editing, refer to the explanations below.
Realtime control in Sequencer mode will affect the
track selected by Track Select.
Tone Adjust will affect the track selected by Track.
• “Using realtime control to edit sounds or effects”
on page 48
• “Editing Programs with Tone Adjust” on page 75
Adjusting the Volume, Mute, and Solo
of each track
You can also edit the mixer parameters directly from
the Control Surface, eight Tracks at a time.
1. Press the MIXER switch under CONTROL
ASSIGN, so that the T1–8 LED lights up.
The switch has two LEDs: one for T1–8, T9–16 and
INPUT. These correspond to Tracks 1–8, Tracks 9–16,
and the audio inputs.
2. Access the Seq P0–2: Play/REC– Control Surface
page.
This page displays and reflects the control surface data.
It’s a convenient place to adjust the sound, since you
can view the actual parameter assignments and the
exact data values.
Note: You can use the Control Surface for control
regardless of the page that is shown in the display.
3. Use sliders 1–8 to adjust the volumes of Tracks 1–8,
respectively.
4. While the display shows Track Play/Mute,
switches 1–8 will change the Play/Mute status of
tracks 1–8.
5. Press the menu button to select “Panel-SW Solo
Mode.”
The menu will close, and the indication of Track Play/
Mute in the display will change to Track Solo.
Alternatively, you can hold down the ENTER switch
and press numeric key 1 to switch between Track
Play/Mute and Track Solo.
6. While the display shows Track Solo, switches 1–8
will turn Solo on/off for tracks 1–8.
Track
Select
Control Assign Switches 1–8
Sliders 1–8 Reset Controls