KORG M3 - Manual (Page 128)

Sampling (Open Sampling System)
120
indicates the zone determined by the Top Key
setting.
• Level adjusts the playback level of the sample. You
can use this to ensure that all samples in a
multisample have a consistent level.
• If you check Constant Pitch, all notes in the index
zone will sound the sample at its original pitch.
• “Pitch” adjusts the sample pitch for each index.
You can use the Pitch BPM Adjust menu command
to set the loop interval to the desired tempo. For
details, please see “Pitch BPM Adjust” on page 351
of the Parameter Guide.
Ripping – P5: Audio CD
The M3 allows you to “rip” digital audio data from an
audio CD inserted in a USB A connected USB CD-R/
RW drive (commercially available).
For details on the ripping procedure, please see
“Destination” on page 351 of the Parameter Guide.
Converting a multisample to a
program
In pages P0: Recording–P4: Controllers, you can select
and execute the Convert MS To Program menu
command. When you execute this command, the
settings of the currently selected multisample will be
converted into a program. In Program mode you can
make filter, amp and effect settings etc., and play the
sample as a program. The resulting Program can be
used in a Combination or Song.
1. Use “Multisample Select (MS)” to select the
multisample that you want to convert to a
program.
2. Choose “Convert MS To Program” to open the
dialog box.
3. Press the text edit button to open the text edit
dialog box, and input a new program name (up to
24 characters). By default, this will be the name of
the multisample.
4. “Use Destination Program Parameters”
unchecked:
When you execute, the multisample of the conversion-
destination program will be replaced by the
multisample you select here, and the other program
parameters will be initialized. The program will
reproduce the sound you heard in Sampling mode.
The program will be converted with an Oscillator
Mode
(Prog P1) of Single.
“Use Destination Program Parameters” checked:
When you execute, the multisample of the conversion-
destination program will be replaced by the
multisample you select here, but the other program
parameters will not be initialized. Choose this if you
want to use the parameter settings of an existing
program.
If you check Use Destination Program
Parameters
, please be aware of the following
point.
The conversion-destination program’s Oscillator
Mode
must be Single. If this is not the case, a
message of “Oscillator Mode conflicts” will appear
when you attempt to execute. Please change the
Oscillator Mode
setting of the conversion-
destination program.
5. Use the To “Program” field to specify the
conversion-destination program.
We recommend that you use bank USER-E as the
program bank for Sampling mode.
6. Press the OK button to execute.