KORG M3 - Manual (Page 214)

Appendices
206
Installing the EXB-M256
Before you proceed with installation, please read the
preceding “Safety cautions” and “Cautions when
installing option boards or memory.”
You must leave the AC power cable disconnected
until you’ve finished the entire process of option
board installation.
Be careful not to cut your hand on any metal parts
of the sound module or option board.
The EXB-M256 can be used only with compatible
products manufactured by Korg. It is not
compatible with conventional computers. Also,
using a commercially available memory board as a
substitute for the EXB-M256 will cause
malfunctions. Please use the correct product only
as directed.
1. Using your Phillips (+) screwdriver, remove the
two screws from cover “B,” and then remove cover
“B” from the sound module.
Don’t lose the screws that you remove.
2. Verify the location in which you’ll be installing
the EXB-M256.
Making sure that the EXB-M256 is oriented correctly,
insert it diagonally into the slot of the sound module as
shown in the illustration, inserting it as far as it will go.
3. As shown in the illustration, gently press down
the EXB-M256 so that it lies flat. When the EXB-
M256 clicks into place, locking tabs will hold it in
place.
4. Attach cover “B” to the sound module, and fasten
it using the two screws you removed in step (2).
5. When you’ve finished the entire procedure, turn
on the power and verify that the EXB-M256 was
installed correctly. (See “Verifying installation” on
page 203)
Removing the EXB-M256
Before you proceed, please read the preceding “Safety
cautions” and “Cautions when installing option boards
or memory.”
You must leave the AC power cable disconnected
until you’ve finished the entire process of option
board installation.
Be careful not to cut your hand on any metal parts
of the sound module or option board.
1. Remove cover “B” from the sound module as
described in steps 1–2 of “Installing the EXB-
M256.”
2. Spread the locking tabs to left and right until the
EXB-M256 pops up into a diagonal position.
3. Pull the EXB-M256 straight out and remove it from
the slot.
4. Re-attach cover “B” as described in step 5 of
“Installing the EXB-M256.”