KORG M3 - Manual (Page 118)

Sampling (Open Sampling System)
110
Sampling and editing in Sampling mode
In Sampling mode, you can record samples, and edit
sample data that you sampled or loaded from media
(including WAVE and AIFF formats). You can also
assign the edited samples to indexes (zones) to create a
multisample.
Sampling mode page structure
For details on how to access each mode and page,
please see “Basic operations” on page 22.
Sampling can be performed in any page P0–P9 of
Sampling mode by using the SAMPLING REC switch
and the START/STOP switch. Recording-related
settings such as input level are made by the parameters
of P0: Recording, and these settings are valid for the
other pages as well.
The selected multisample or sample can be played
from the keyboard in any page, allowing you to hear
the results of your editing in each page.
Creating multisample indexes
and sampling – P0: Recording
Here’s how to create indexes in a multisample, and
assign a sample to each index.
1. Press the MODE SAMPLING switch to enter
Sampling mode.
2. Access the P0: Recording– Recording page.
3. Select “Multisample Select,” and create a
multisample.
To create a new multisample, press the “Multisample
Select” popup button. Then press a Multisample No. in
the list for which no name has been entered, or use the
numeric keys 0–9 to input a number and then press the
ENTER switch.
A dialog box will appear.
If you want to create a stereo multisample, check the
Stereo
box, and press the OK button.
If you want to create a monaural multisample, uncheck
the Stereo box, and press the OK button.
4. Press the Create button to create an index.
Immediately after the power is turned on, “Index” will
be 001/008. This indicates that there are eight indexes,
and that the first index is selected.
Press the Create button several times. Each time you
press it, an index will be created. The keyboard display
will indicate the zone and original key location of each
index.
Note: The index that is created when you press the
Create button will be created according to the P0:
Recording– Preference page Create Zone Preference
settings. (These settings can also be made in P3:
Multisample Edit page)
Page Main content
REC
ORDING
P0: Recording
Record (sample) a sample. Select the
sample or multisample to be recorded,
make detailed settings for recording,
make AUDIO INPUT settings, and view
the memory status.
EDIT
P1: Sample Edit
Sample, or edit the waveform etc. of
samples you loaded into internal
memory using Media mode.
P2: Loop Edit
Set playback parameters for samples,
such as start, loop start, end address,
loop on/off, and reverse playback on/off.
Perform editing operations such as Time
Slice and Time Stretch.
P3: Multisample
Edit multisamples. Edit settings such as
sample assignments, zones, and original
key.
C
ONTROLLER & A
UDIO CD
P4: Controllers
Setup
Controller settings.
P5: Audio CD Play back or rip from an audio CD.
EFFECT
P8: IFX
Bus and master effect send level settings.
Insert effect routing, selection, and
settings.
P9: MFX/TFX
Master effect routing, selection, and
settings.
Total effect selection and settings.
Keyboard
& Index
Multisample
Select
Popup
Index
Create
Sample
Select