KORG M3 - Manual (Page 123)

Sampling and editing in Sampling mode Basic sampling procedure
115
Quick Start
Introduction
Setup
Program
Combination
Sequencer
Sampling
Global
Media
Effect
KARMA
Drum Track
Other
Appendices
Check the sampled content
1. Play the keyboard.
Press the “OrigKey” key to hear the sound you
sampled.
Applying an insert effect to a sample
and resampling the result
The process of applying an insert effect etc. to a
sampled sound and then sampling it once again is
called “resampling.”
Automatic “resampling”
1. In the P0: Recording– Recording page, assign the
sample that you want to resample to Sample
(Sample Select).
When the power is first turned on, the assigned sample
will be set to Orig.Key C2.
2. Select the menu command “Auto Sampling
Setup.” A dialog box will appear.
3. Choose “Auto Resample through IFX.” In “IFX,”
select the effect you want to use.
4. Press the OK button to execute the command.
Settings for sampling have now been made.
5. In the P0: Recording– Audio In/Setup page, use
“Key” to specify the sample that you want to
resample.
Normally you will set this to match the Orig Key of the
Recording page.
6. In the P0: Recording– Preference page, make sure
that “Auto +12 dB On” is checked.
7. In the P8: IFX– Insert FX Setup page, set IFX1 to
070: Reverb Hall, and turn IFX On/Off ON.
Play the note that’s specified for “Key,” and verify that
reverb is applied.
Also make sure that the Bus following IFX1 is set to L/
R.
8. Press the SAMPLING REC switch, and then the
SAMPLING START/STOP switch.
The sample assigned to Key will play automatically,
and resampling will begin.
When the sample finishes playing, resampling will
end.
The sample that was created by resampling will
automatically be assigned to Sample Select.
Note: In Sampling mode, the P8: IFX– Routing page
Bus (IFX/Output) Select
parameter will automatically
be set to L/R when resampling ends. This prevents an
insert effect from being applied in duplicate when you
monitor the results of resampling through an insert
effect.
If you want to apply an insert effect once again, re-
select IFX1.
Parameter settings made by “Auto Resample
through IFX”
• P0: Recording– Audio In/Setup
INPUT1 Bus Select: Off
Turn off the input from the INPUT 1, 2 and S/P DIF
L/R jacks.
Source Bus : L/R
The sound sent to the L/R will be sampled.
Trigger : Sampling START SW
After you’ve pressed the SAMPLING REC switch
to enter sampling-ready mode, resampling will
begin when you press the SAMPLING START/
STOP
switch.
Resample : Auto
The sample assigned to the index will be resampled
automatically.
Recording Level: 0.0
This is the default setting for resampling.
• P0: Recording– Recording
Save to: RAM
The data will be written to RAM memory.
Sampling Mode: Stereo
The sound of the internal L/R channels will be sam-
pled in stereo.
• P0: Recording– Preference
Auto +12dB On: On
The +12 dB setting will automatically be turned on
for the samples you record.