Kyocera FS-6700 - Manual (Page 112)

2-43
Chapter 2 Operating the Laser Printer
Note that only reading fonts and printing a list of partitions are possible when a font card is
inserted. The following sections explain each of these operations.
Each operation is described below.
Reading Fonts from a Memory Card
Fonts can be read into the printer’s internal memory from optional font cards. The font read can
then be selected from the printer’s control panel. Font cards are automatically read into the printer
when the printer’s power is turned on. The operation described here is performed while the
message display reads
Ready .
1. Check that the font card is inserted into the memory card slot. Bring up the menu >Read
fonts on the message display. This display only appears if a font card is inserted.
2. Press the ENTER key. ? will appear.
Press the CANCEL key to stop reading fonts.
3. Pressing the ENTER key again will cause Processing to appear in the lower part of the
message display and font data to be read from the font card.
4. After fonts have been read, the message display will return to >Read fonts .
5. Pressing the EXIT key will cause the message display to return to Ready .