Kyocera FS-6700 - Manual (Page 113)

2-44
Reading Macros from a Memory Card
Macro data on a memory card can be registered on the printer. Registered macro data can be
used just like macro data located in printer memory. If a memory card already containing macro
data is inserted in the printer, that macro data will be read into the printer automatically when the
printer’s power is turned on.
The operation described here is performed when a memory card is inserted while the message
display reads
Ready .
Note
Macro data on a memory card has no effect on printer memory.
1. Check that the memory card containing macro data is inserted. Bring up the menu >Read
macro on the message display. This display only appears if a memory card containing macro
data is inserted.
2. Press the ENTER key. ? will appear.
Press the CANCEL key to stop reading macro data.
3. Pressing the ENTER key again will cause Processing to appear in the lower part of the
message display and macro data to be read from the memory card.
4. After macro data has been read, the message display will return to >Read macro .
5. Pressing the EXIT key will cause the message display to return to Ready .
Notes
● If the name of a macro on the memory card is the same as that in printer memory, the macro
data on the memory card with the conflicting name will not be registered.
● Registered macro data will be lost if the memory card is pulled out. Re-execute >Read macro
if this happens.
2.14. Memory Cards