Kyocera FS-6700 - Manual (Page 63)

1-38
1.6. Memory Card
A memory card is a microchip card containing, for example, nonresident fonts and/or macros,
forms, etc. The printer reads the contents of the card into its internal memory when power is
switched on. The presence of this data in the printer memory can be confirmed on the status
printout.
Note
The maximum card capacity that can be used is 32 Megabytes. The type of the memory card to be
used must be of either flash memory card (+5 V type) or SRAM-type and conform to the PCMCIA
2.1 (JEIDA 4.2) standards. Please use memory cards recommended by Kyocera.
The memory card slot is located at the bottom right of the printer.
To insert and use a memory card:
1. Switch printer power off.
Note
Do not insert or remove a memory card while power is on. If the memory card is removed while the
printer is on, damage could result in the printer’s electronics or the memory card.
2. Insert the memory card in the slot. Insert it face up, connector end first. Push it in all the way.
Memory Card
Memory Card Slot
[PC CARD (MEMORY)]
1.6. Memory Card