Kyocera FS-6700 - Manual (Page 93)

2-24
2.4. Configuring Interfaces
The printer is equipped with both a parallel and serial interface. Independent settings can be
made for each interface. Optional interfaces can also be installed.
To configure each interface, press the MODE key and use the + or – key to select the interface you
wish to make settings for.
Note
This interface selection does not select which interface data will be received from. The printer
automatically selects that interface.
Parallel Interface Mode
The parallel interface mode of this printer supports a bi-directional/high-speed mode. Normally,
this interface is used under the default setting
Nibble (high) .
Parallel Interface Mode
Display Description
Nibble (high) High speed data communication is used in compliance with the IEEE
1284 standard.
Auto The printer automatically changes its communication mode.
Normal The parallel interface is configured according to standard specifications.
High speed The parallel interface is in high-speed mode.
After setting the interface, be sure to reset the printer or turn the power off at least once. The new
setting will be enabled thereafter.
2.4. Configuring Interfaces