Kyocera FS-6700 - Manual (Page 97)

2-28
2.7. Sleep Timer Setting
This printer is equipped with a sleep timer function for conserving energy in cases where there has
been no operation from the control panel or data has not been received for a predetermined period
of time.
The sleep timer can be set anywhere from 0 to 120 minutes in 5-minute increments. Setting the
sleep timer to 0 turns it off. The sleep timer is set at the factory to 30 minutes.
Once the set time arrives, the printer will display Sleeping and all indicators will go out. This
minimizes the amount of energy used.
Pressing a key on the control panel, opening and closing a cover, or sending data to the printer
while it is displaying
Sleeping will cause the printer to display Please wait and it will begin
warming up. After it warms up, the printer’s ON LINE indicator will light and it will enter ready
status.
The printer will enter Sleeping mode when the set time arrives even during mode selection or while
a maintenance message is being displayed.
Note
The printer environment last set is still maintained even though all indicators are out while the
printer is in Sleeping mode.
2.7. Sleep Timer Setting