Liebert POWER PROTECTION STATIC TRANSFER SWITCH - Manual (Page 48)

Installation Drawings
40
Figure 28 Control wiring for the network interface card (NIC) option
PS213005 REV. 2
NETWORK INTERFACE CARD (NIC) 416241GX
AND LOCAL ELECTRICAL CODES. LIMITED BY INTERNET STANDARDS. 6. ALL WIRING MUST BE IN ACCORDANCE WITH NATIONAL OF STATIC TRANSFER SWITCH FOR LOCATION OF NETWOR
K
5. REFER TO CONTROL CONNECTION LOCATION DIAGRAM SEPARATE FROM POWER WIRING. CONTROL WIRING RUNS 4. ALL CONTROL WIRING (BY OTHERS) MUST BE RUN SHOULD NOT BE COMBINED IN THE SAME CONDUIT. MANUAL FOR CONFIGURING THE NETWORK INTERFACE 3. REFER TO INSTALLATION,
OPERATION & MAINTENANCE
1. WIRE SIZE AND TYPE: 10/100 BASE-T ETHERNET CABLE WITH RJ45 PLUG CONNECTOR. THE LENGTH IS NOTES: INTERFACE CARD OPTION.
13
2
TB2
P18
J3
ETHERNET NETWORK
RJ-45 CONNECTOR SEE NOTES 1 & 2
CUSTOMER SUPPLIED
INTERCONNECTING CABLE
+
-
CUSTOMER SUPPLIED
INTERCONNECTING CABLE TO MODBUS
SEE NOTE 2
WITH TWISTED PAIR CABLE #22 AWG MINIMUM. SIGNAL 2. MAXIMUM CABLE LENGTH 1000 FEET (300 METERS) VOLTAGE 5VDC, CURRENT 10mA.
RS-232 (DB9
CONNECTOR) FOR SETUP ONLY. USES
STANDARD COMPUTER
SERIAL PORT CABLE
CARD (NIC).
"NO CUSTOMER CONNECTION" "NO CUSTOMER CONNECTION"