Proxim ORiNOCO AP-700 - Manual (Page 155)

Using the Command Line Interface (CLI) AP-700 User Guide
Other Network Settings
155
Server Status : notReady
Server Addressing Format : ipaddr
IP Address/Host Name : 0.0.0.0
Destination Port : 1812
VLAN Identifier : -1
MAC Address Format : dashdelimited
Response Time : 3
Maximum Retransmission : 3
Authorization Lifetime : 0
Accounting Update Interval : 0
Accounting Inactivity Timer : 5
Index : 4
Primary/Backup : Backup
Profile Name : Management Access
Server Status : notReady
Server Addressing Format : ipaddr
IP Address/Host Name : 0.0.0.0
Destination Port : 1812
VLAN Identifier : -1
MAC Address Format : dashdelimited
Response Time : 3
Maximum Retransmission : 3
Authorization Lifetime : 0
Accounting Update Interval : 0
Accounting Inactivity Timer : 5
Set Rogue Scan Parameters
Perform the following command to enable or disable Rogue Scan on a wireless interface and configure the scanning parameters.
The cycletime parameter is only configured for background scanning mode.
[Device-Name]>set rscantbl <3, 4> mode <1 for background scanning, 2 for continuous scanning> cycletime
<cycletime from 1-1440 minutes> status <enable, disable>
NOTE
Rogue Scan cannot be enabled on a wireless interface when the Wireless Service Status on that interface is shutdown. First, resume
service on the wireless interface.