Proxim ORiNOCO AP-700 - Manual (Page 158)

Using the Command Line Interface (CLI) AP-700 User Guide
Parameter Tables
158
– MAC Access Control Parameters - Control wireless access based on MAC address
– Rogue Scan Configuration Table - Enable and configure Rogue Scan to detect Rogue APs and clients.
– Hardware Configuration Reset - Disable or enable hardware configuration reset and configure a configuration reset password.
– VLAN/SSID Parameters - Enable the configuration of multiple subnetworks based on VLAN ID and SSID pairs.
– Security Profile Table - Configure Security Profiles that define allowed security modes (wireless clients), and encryption and
authentication mechanisms.
• Other Parameters
– IAPP Parameters - Enable or disable the Inter-Access Point Protocol
– Wireless Multimedia Enhancements (WME)/Quality of Service (QoS) parameters - Enable and configure Wireless Multimedia
Enhancement/Quality of Service parameters, QoS policies, mapping priorities, and EDCA parameters. Apply a configured QoS policy
to a particular SSID.
System Parameters
Name Type Values Access CLI Parameter
System Group N/A R system
Name DisplayString User Defined RW sysname
Location DisplayString User Defined RW sysloc
Contact Name DisplayString User Defined RW sysctname
Contact E-mail DisplayString User Defined RW sysctemail
Contact Phone DisplayString User Defined
max 254 characters RW sysctphone
FLASH Backup Interval Integer 0 - 65535 seconds RW sysflashbckint
Flash Update 0
1 RW sysflashupdate
System OID DisplayString N/A R sysoid
Descriptor DisplayString System Name, flash
version, S/N, bootloader
version R sysdescr
Up Time Integer dd:hh:mm:ss
dd – days
hh – hours
mm – minutes
ss – seconds R sysuptime
Emergency Restore to defaults Resets all parameters to
default factory values RW sysresettodefaults
Note: You must enter the
following command twice to
reset to defaults:
set sysresettodefaults 1