Proxim ORiNOCO AP-700 - Manual (Page 172)

Using the Command Line Interface (CLI) AP-700 User Guide
Parameter Tables
172
Proxy ARP Parameters
IP ARP Filtering Parameters
Broadcast Filtering Table
TCP/UDP Port Filtering
The following parameters are used to enable/disable the Port filter feature.
TCP/UDP Port Filtering Table
The following parameters are used to configure TCP/UDP Port filters.
Name Type Values Access CLI Parameter
Proxy ARP Group N/A R parp
Status Integer enable
disable (default) RW parpstatus
Name Type Values Access CLI Parameter
IP ARP Filtering Group N/A R iparp
Status Integer enable
disable (default) RW iparpfltstatus
IP Address IpAddress User Defined RW iparpfltipaddr
Subnet Mask IpAddress User Defined RW iparpfltsubmask
Name Type Values Access CLI Parameter
Broadcast Filtering
Table Table N/A R broadcastflttbl
Index Integer 1-5 N/A index
Protocol Name DisplayString N/A R protoname
Direction Integer ethertowireless
wirelesstoether
both (default) RW direction
Status Integer enable
disable (default) RW status
Name Type Values Access CLI
Port Filtering Group N/A R portflt
Port Filter Status Integer enable (default)
disable RW portfltstatus
Name Type Values Access CLI
Port Filtering Table Table N/A R portflttbl
Table Index N/A User Defined
(there are also 4
pre-defined indices, see
Port Number below for
more information)
R index
Port Type Octet String tcp
udp
tcp/udp RW porttype
Port Number Octet String User Defined
(there are also 4
pre-defined protocols:
Index 1: NetBios Name
Service – 137, Index 2:
NetBios Datagram
Service – 138, Index 3:
NetBios Session
Service – 139, Index 4:
SNMP Service – 161) RW portnum