Proxim ORiNOCO AP-700 - Manual (Page 182)

Using the Command Line Interface (CLI) AP-700 User Guide
Parameter Tables
182
NOTE
A priority mapping needs to be specified for a QoS Policy. The priority mapping depends on the type of policy configured. For Layer 2
policy types (inbound or outbound) a mapping index from the 802.1p to 802.1D table should be specified. For Layer 3 policy types
(inbound or outbound) a mapping index from the IP DSCP to 802.1D table should be specified. The mapping index, in both cases,
depends on the number of mappings configured by the user. For SpectraLink policy type a mapping is not required.
Specifying the Mapping between 802.1p and 802.1D Priorities
The QoS 802.1p to 802.1D Mapping Table specifies the mapping between 802.1P and 802.1D priorities.
Specifying the Mapping between IP Precedence/DSCP Ranges and 802.1D Priorities
The QoS IP DSCP to 802.1D Mapping Table specifies the mapping between IP Precedence/DSCP Ranges and 802.1D priorities.
QoS Enhanced Distributed Channel Access (EDCA) Parameters
The following commands configure the client (STA) and AP Enhanced Distributed Channel Access (EDCA) parameters.
The EDCA parameter set provides information needed by the client stations for proper QoS operation during the wireless contention period.
These parameters are used by the QoS enabled AP to establish policy, to change policies when accepting new stations or new traffic, or to
adapt to changes in the offered load. The EDCA parameters assign priorities to traffic types where higher priority packets gain access to the
wireless medium more frequently than lower priority packets.
NOTE
We have defined default recommended values for EDCA parameters; we recommend not modifying EDCA parameters unless strictly
necessary.
Name Type Values Access CLI Parameter
QoS 802.1p to 802.1D
Mapping Table Table N/A N/A qos1pto1dtbl
Table Index (Primary
Index) Integer 0 - 7 R index
802.1D Priority
(Secondary Index) Integer 0 - 7 R 1dpriority
802.1p Priority Integer 0 - 7 RW 1ppriority
Table Row Status Row Status enable
disable
delete RW status
Name Type Values Access CLI Parameter
QoS IP DSCP to 802.1D
Mapping Table Table N/A N/A qosdscpto1dtbl
Table Index (Primary
Index) Integer 0 - 7 R index
802.1D Priority Integer 0 - 7 R 1dpriority
IP DSCP Lower Limit Integer 0 - 62 RW dscplower
IP DSCP Upper Limit Integer 1 - 63 RW dscpupper
Table Row Status Row Status enable
disable
delete RW status
Name Type Values Access CLI Parameter
EDCA Table Table N/A N/A qosedcatbl
Table Index Integer 1 - 4 R index
CWmin Integer 0 - 255 RW cwmin
CWmax Integer 0 - 65535 RW cwmax
AIFSN Integer 2 - 15 RW aifsn
Tx OP Limit Integer 0 - 65535 RW txoplimit
MSDU Lifetime Integer 0 - 500 RW msdulifetime
AC Mandatory Truth Value true
false RW acmandatory
QAP EDCA Table Table N/A N/A qosqapedcatbl
Table Index Integer 1 - 4 R index
CWmin Integer 0 - 255 RW cwmin