Proxim ORiNOCO AP-700 - Manual (Page 198)

Regulatory Information AP-700 User Guide
Information to the User
198
Information to the User
This document provides regulatory information for the following products:
•
Wireless Client products such as the PC Card, USB Client.
• Wireless Base Station products such as the AP-700, AP-4000, AP-4000 11a Upgrade Kit, AP-4000 11g Cardbus Kit, AP-600 11abg
Upgrade Kit, AP-2500, AP-4000, ORiNOCO AP-600, AP-600 11g Upgrade Kit.
Wireless Client and Base Station products are wireless network products based on IEEE 802.11 standards for wireless LANs as defined and
approved by the Institute of Electrical and Electronics Engineers. Products designed according the IEEE 802.11a and IEEE 802.11g
standards standard use Orthogonal Frequency Division Multiplexing (OFDM) radio technology. Products designed according the
IEEE 802.11b standard use Direct Sequence Spread Spectrum (DSSS) radio technology. These products are designed to be interoperable
with any other wireless product that complies with the corresponding standard.
The Wireless Fidelity (Wi-Fi) certification is defined by the Wi-Fi Alliance.
IMPORTANT SAFETY INSTRUCTIONS
When using this device, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons,
including the following:
a. Do not use this product near water, for example, near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement or near a
swimming pool.
b. Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.
c. Do not use this product to report a gas leak in the vicinity of the leak.
Additional Installation Requirements for Base Station products
When installing Base Stations the placement of the device must also satisfy the following installation requirements:
a. Connect the unit to an AC wall outlet (100-240 V AC) using only the standard power cord/adapter provided with the product.
b. Placement must allow for easily disconnecting the power cord/adapter of the device from the AC wall-outlet.
c. Do not cover the device, or block the airflow to the device with any other objects. Keep the device away from excessive heat and humidity
and keep the device free from vibration and dust.
d. Installation must at all times conform to local regulations.
e. When the device will be connected to an outdoor antenna system, consult the documentation that came with the outdoor antenna kit for
additional regulatory information, safety instructions and installation requirements.
f. Always disconnect the cables before opening the equipment enclosure or touching an uninsulated cable, jack or internal component.
g. Connections to the USB Client device must be made with the shielded cable provided in the kit.
h. Connections to Base Station products can be made with either Unshielded Twisted Pair (UTP) or Shielded Twisted Pair cabling (STP)
cabling. When using the device in combination with Power over Ethernet, only use Shielded Twisted Pair cabling (STP).
SAVE THESE INSTRUCTIONS