Proxim ORiNOCO AP-700 - Manual (Page 22)

Getting Started AP-700 User Guide
Hardware Installation
22
Installing the Security Cover
You can optionally install a security cover to deter unauthorized access to the AP-700. The security cover is a plastic cover that prevents
access to the cabling and to the Reset and Reload buttons.
NOTE
You cannot connect an RS-232 cable to the AP-700 when a security cover is installed.
1. Slide the hinging end of the security cover into the hole on the rear panel of the AP-700 to the left of the connectors.
2. Use two screws to screw the right side of the security cover to the RS-232 screw holes on the rear panel of the AP-700.
Mounting the AP-700
Conduct a site survey to determine the best location for your device. Once you have chosen a final location for your unit, mount the AP-700 to
a wall or a T-bar ceiling as follows:
Mounting the AP-700 to a Ceiling
1. Attach the mounting plate to the bottom of the AP-700 by lining up the keyholes and attaching it with two screws.
2. Snap the tabs onto the ceiling T-bar. Rotate the AP-700 until it snaps on to the T-bar.
Figure 2-4 AP-700 Mounting Plate