Proxim ORiNOCO AP-700 - Manual (Page 173)

Using the Command Line Interface (CLI) AP-700 User Guide
Parameter Tables
173
Alarms Parameters
SNMP Table Host Table Parameters
When creating table entries, you may either specifying the argument name followed by argument value. CLI applies default values to the
omitted arguments. Due to the nature of the information, the only argument that can be omitted is the “comment” argument.
Syslog Parameters
The following parameters configure the Syslog settings.
NOTE
When Heartbeat is enabled, the AP periodically sends a message to the Syslog server to indicate that it is active. The frequency with
which the heartbeat message is sent depends upon the setting of the Heartbeat Interval.
Syslog Host Table
The table described below configures the Syslog hosts that will receive message from the AP. You can configure up to ten Syslog hosts.
Protocol Name DisplayString User Defined
(there are also 4
pre-defined protocols,
see
Port Number above)
RW protoname
Interface Bitmask Integer32 0 or 2 - no interfaces
(disable)
1 or 3 - Ethernet
4 or 6 - Wireless
5 or 7 - all interfaces
(default is 7) RW ifbitmask
Status (optional) Integer enable (default for new
entries)
disable (default for
pre-defined entries)
delete RW status
Name Type Values Access CLI Parameter
SNMP Trap Host Table Table N/A R snmptraphosttbl
Table Index Integer User Defined N/A index
IP Address IpAddress User Defined RW ipaddr
Password DisplayString User Defined (up to 64
characters) W passwd
Comment (optional) DisplayString User Defined (up to 254
characters) RW cmt
Status (optional) Integer enable (default)
disable
delete RW status
Name Type Values Access CLI
Syslog Group N/A R syslog
Syslog Status Integer enable
disable (default) RW syslogstatus
Syslog Port Octet String 514 R syslogport
Syslog Lowest Priority
Logged Integer 1 – 7
1 = LOG_ALERT
2 = LOG_CRIT
3 = LOG_ERR
4 = LOG_WARNING
5 = LOG_NOTICE
6 = LOG_INFO (default)
7 = LOG_DEBUG RW syslogpritolog
Heartbeat Status Integer enable (1)
disable (2) (default) RW sysloghbstatus
Heartbeat Interval (seconds) Integer 1 – 604800 seconds;
900 sec. (default) RW sysloghbinterval
Name Type Values Access CLI Parameter