Paradyne 9788 User Manual
Page 102
4. Configuration Options
4-62
December
2002
9700-A2-GB20-20
RIP
Possible Settings: None, Standard_out
Default Setting: None
Specifies which Routing Information Protocol (RIP) is used to enable routing of
management data between devices.
Display Conditions – This option appears only when Port Use is set to Net Link.
None – No routing is used.
Standard_out – The device will send standard RIP messages to communicate routing
information about other FrameSaver units in the network. Standard RIP messages
received on this link are ignored.
NOTE: The router must be configured to receive RIP on the port connected to the
COM port, configured as the management interface. To create this management
interface, make sure that Node or COM Port IP information has been set up (refer to
Configuring Node IP Information
Table 4-25. Communication Port Options (4 of 4)