Network 1 frf.8, Encapsulation mode (9783 and 9788), Network 1 frf.8 encapsulation mode (9783 and 9788) – Paradyne 9788 User Manual

Page 47

Advertising
background image

4. Configuration Options

9700-A2-GB20-20

December 2002

4-7

Network 1 Channel (9720)

Possible Settings: B1, B2
Default Setting: B1

Specifies the B channel used for data transfer when the line rate is 64 kbps.

Display Conditions – Network 1 Channel appears only when Network 1 Operating Rate
is set to 64.

B1 – The B1 channel is used for data transfer.

B2 – The B2 channel is used for data transfer.

Port-1 Port Type (9788 CSU/DSU)

Possible Settings: E530, V.35, X.21
Default Setting: V.35

Specifies the port type of the data port.

E530 – The port is configured as an EIA-530-A-compatible DCE. An EIA-530-A-
compatible DTE may be directly connected to the DB25 connector for the port.

V.35 – The port is configured as a V.35-compatible DCE. A V.35-compatible DTE may be
connected to the port using a DB25-to-MS34 adapter.

X.21 – The port is configured as an X.21-compatible DCE. An X.21-compatible DTE may
be connected to the port using a DB25-to-DB15 adapter.

Network 1 FRF.8 Encapsulation Mode (9783 and 9788)

Possible Settings: Translational, Transparent
Default Setting: Transparent

Specifies the type of FRF.8 upper-layer protocol encapsulation used on the link for each
pair of interoperable Frame Relay and ATM PVCs.

Translational – Encapsulated data is translated (RFC 1490 to RFC 1483). FrameSaver
multiplexing and SLV communications are not supported in this mode.

Transparent – Encapsulated data is forwarded without being translated.

Table 4-1.

Easy Install Configuration Options (4 of 4)

Advertising
This manual is related to the following products: