Paradyne 9788 User Manual

Page 161

Advertising
background image

7. Operation and Maintenance

9700-A2-GB20-20

December 2002

7-25

DLCI

DLCI (16–1007)

VPI,VCI
(0–15 VPI,
31–255 VCI)

Identifies the source/destination of the
specified virtual circuit. Management PVCs
built on the ATM link display the VPI/VCI
value in parentheses instead of a DLCI
number.

EDLCI

0 to 62

IP

PM

For multiplexed DLCIs, a number from 0 to
62 identifies an individual link embedded
within a DLCI.

For IP Enabled DLCIs, IP is displayed. For
DLCIs not IP enabled that are the primary
destination of a payload managed PVC,
PM is displayed.

Status

Identifies whether the physical interfaces,
LMIs, and DLCIs are all enabled and active
for this PVC connection.

Active

The PVC is currently active. Both
Source and Destination Statuses must
be Active for the circuit to be active.

Inactive

The PVC is inactive because:

– Alarm conditions and network and

SLV communication status indicate
that data cannot be successfully
transmitted.

– The unit has disabled the interface or

frame relay link due to internal
operating conventions.

Disabled

The PVC cannot be activated as a result
of how the unit was configured. The
PVC may be disabled at one or both
ends of:

– The physical interface, or

– The frame relay link.

Invalid

Some portion of the PVC connection is
not fully configured.

Table 7-9.

PVC Connection Status Screen (2 of 2)

Field

Display

What It Indicates

Advertising
This manual is related to the following products: