Paradyne 9788 - Manual (Page 60)

4. Configuration Options
4-20 December 2002 9700-A2-GB20-20
Configuring Network Interfaces
Configuration of network interface is described in the following sections:
Configuring the Network Physical Interface
Configuring Frame Relay for the Network Interface
Configuring DLCI Records for the Network Interface (9720)
Configuring Circuit Records for the Network Interface (9783, 9788)
Configuring ATM for the Network Interface (9783, 9788)
Configuring the Network Physical Interface
When configuring network interface physical characteristics, select Physical from
the Network menu. See
Table 4-7, Network Physical Interface Options (9720) ,
Table 4-7, Network Physical Interface Options (9720) , or Table 4-9, Network
Physical Interface Options (9788) .
Main Menu →Configuration→Network→Physical
Table 4-7. Network Physical Interface Options (9720)
Operating Rate
Possible Settings: AutoRate, 64, 128, 144
Default Setting: AutoRate
Specifies the IDSL line rate.
AutoRate – The line rate is automatically detected when the frame relay LMI is brought up
on one or both channels.
64 – The line rate is 64 kbps. One B channel is used for the data transfer, and automatic
rate detection is disabled.
128 – The line rate is 128 kbps. Both B channels are used for the data transfer, and
automatic rate detection is disabled.
144 – The line rate is 144 kbps. Both B channels are used for the data transfer, and
automatic rate detection is disabled.
Channel
Possible Settings: B1, B2
Default Setting: B1
Specifies the B channel used for data transfer when the line rate is 64 kbps.
Display Conditions – Channel appears only when Operating Rate is set to 64.
B1 – The B1 channel is used for data transfer.
B2 – The B2 channel is used for data transfer.