System error messages – NCR S10 User Manual

Page 115

Advertising
background image

Error Messages

System Error Messages

NCR S10 Desktop Server User Guide

B-3

System Error Messages

A system error message indicates a problem with the
computer itself. A message of this type normally
appears during the power-on self-test, before the
operating system prompt appears.

Table B-1 lists system error messages and the
corresponding corrective measures.

Table B-1
Error Messages

Message

Action

CMOS battery error

Replace the RTC chip or contact your dealer.

CMOS Checksum Error

Check the RTC chip and the necessary jumper. If the
battery is still good, run Setup.

Display card mismatch

Run Setup.

Diskette drive error

Diskette may be bad. If not, replace the diskette drive
or cable.

Diskette drive controller error or
not installed

Check and connect the control cable to the diskette
controller.

Diskette drive A type mismatch

Run Setup and select the proper drive type.

Diskette drive B type mismatch

Run Setup and select the proper drive type.

Advertising