Configuring the pci adapters, C-16 – NCR S10 User Manual
Page 136
Sample Configurations
Sample RAID Configuration
C-16
NCR S10 Desktop Server User Guide
9.
Press [Esc] to return to the main menu in BIOS
Setup.
10.
Select System Security. On Page 1, set the
parameters as follows:
Disk Drive Control
Diskette Drive
[Normal]
Fixed Disk Drive
[Normal]
System Boot Drive
[Drive A then C]
On Board Communication Ports
Serial Port 1 Base Address
[3F8h]
Serial Port 2 Base Address
[2F8h]
Parallel Port Base Address
[Parallel 1 (3BCh)]
Operation Mode [Stndrd PP (SPP)]
Mode
EPP Version Selection
[1.7]
Setup Password
[None]
Power On Password
[None]
11.
Press [Esc] to return to the main menu in BIOS
Setup.
To configure the PCI adapters, follow these steps:
1.
Select PCI System Configuration from the main
menu in BIOS Setup.
2.
Use the up and down arrow keys to select the PCI
slot number. Use the right and left arrow keys to
change the IRQ Level for INTA Pin settings.
Configuring the PCI
Adapters