Sample raid configuration, Installing the hardware, C-12 – NCR S10 User Manual
Page 132
Sample Configurations
Sample RAID Configuration
C-12
NCR S10 Desktop Server User Guide
Sample RAID Configuration
A RAID configuration might consist of the following:
•
Pentium 166 MHz Processor with ECC Memory
Support
•
128 MB System Memory
•
ISA Video Board w/1MB Video RAM
•
PCI Ethernet Adapter (SMC8432BTA)
•
PCI Token Ring Adapter (Olicom OC-3136)
•
PCI RAID Adapter (Mylex)
•
Three 2 GB SCSI wide hard drives connected to the
Mylex RAID controller
•
One 2 GB SCSI narrow hard drive connected to the
onboard AIC-7870 SCSI controller
•
SCSI CD-ROM drive connected to the onboard
AIC-7870 SCSI controller
To install the hardware, follow these steps:
1.
Strap the SCSI IDs for the four 2 GB SCSI disk
drives and the SCSI CD-ROM drive (see the
documentation that came with your drives for
strapping information).
The 2 GB SCSI narrow hard drive connected
to the onboard AIC-7870 SCSI controller should be
SCSI ID 0 and will be used as the system boot drive.
The other three 2 GB SCSI wide hard drives
Installing the
Hardware
Note: