NCR S10 - Manual (Page 40)

Installing the System
Installing Drives
2-22 NCR S10 Desktop Server User Guide
5. Slide the drive into the drive housing. Secure it with
four screws on both sides of the drive housing.
6. Re-attach the drive frame.
7. Re-install the drive housing in the system unit. Use
the round pegs on the system unit surface as guide.
Seat the drive housing firmly on the system unit.
Lock the drive housing into position with the
holding tabs on both sides of the system unit near
the front panel.
8. Match the red stripe on the drive cable with pin 1 on
the drive connector and plug it in.
Figure 2-11
Securing the Drive