NCR S10 - Manual (Page 129)

Sample Configurations
Sample Standard Configuration
NCR S10 Desktop Server User Guide C-9
Send Start Unit Command [yes]
5. Press [Enter] to return to previous menu.
6. Select Advanced Configuration Options and set the
parameters as follows:
Host Adapter BIOS (Config Util...) [Enabled]
Support Removable Disks... [Boot Only]
Extended BIOS Translation... [Enabled]
Display <CTRL-A> Message During
BIOS Initialization... [Enabled]
Multiple LUN Support [Disabled]
BIOS Support for More than 2... [Enabled]
7. Press [Enter] to return to previous menu.
8. Press [Esc] until prompted to save configuration.
Save the configuration and the system reboots.
Sometimes the EISA Configuration Utility will not boot.
If this happens, perform the following procedure:
1. Using the BIOS Setup Utility, disable all PCI
adapters.
2. Boot the EISA Configuration Utility.
3. Configure the system.
4. Return to the BIOS Setup Utility, and re-enable the
PCI adapters.
To configure the memory and other baseboard settings,
follow these steps:
Configuring the
Memory and Other
Baseboard Settings