Installing a tape drive – NCR S10 User Manual
Page 43
Installing the System
Installing Drives
NCR S10 Desktop Server User Guide
2-25
7.
Run Setup to reconfigure the system and to format
the fixed disk, if necessary.
To install a tape drive, follow these steps:
1.
Unplug all cables connected to the drives.
2.
Locate the two holding tabs that attach the drive
housing to the system unit and push both tabs
outward, one at a time, to release the drive housing.
See Figure 2-10.
3.
Carefully lift up the drive housing.
4.
Detach the 3.5-inch drive frame from the 5.25-inch
drive housing by removing the two screws securing
the metal frames.
5.
Slide the tape drive into the drive bay and secure it
with screws. See Figure 2-11.
6.
Plug one end of the data cable into the connector on
the tape controller and the other end to the rear of
the tape drive.
7.
Plug the power supply cable to the power connector
on the rear of the tape drive.
Installing a Tape Drive